NOTE: This guide is mainly for recorders with similar Menu Bar interface (see image below):

Blind Access the Menu

1. Access then Menu - If you can't see the icons below when you right-click, follow the steps accordingly AND carefully:
   1. Right-click to pull up the Menu bar.
   2. Drag the mouse pointer to the bottom-left most corner (even if you can't see it).
      
      
   3. Move the mouse very slightly upward then to the right (for the arrow to be placed correctly on the Menu icon).
   4. Left-click to select.
      
2. Once the Menu box showed up, click on Setup. Login if necessary

Change Overscan

Overscan: Auto

1. Go to Display > Display Configuration.
2. Set Enable Overscan to AUTO.
3. Click on Apply to save the settings.
   1. If you are now able to see the entire screen, end of troubleshooting.
   2. If there are still some cut edges, proceed to the next step.

Overscan: Manual

1. Set Enable Overscan to Manual.
2. Click on Setup beside it.
   
   
   
3. Adjust the following depending on the issue:
   1. Scale – adjusts the size of the red box (if you cannot see the red lines on all sides, scale down.
      
      
      
   2. X Offset – adjusts the position of the red box horizontally(50% places it at the center):
      1. Lower number, box goes to the left
      2. Higher number, box goes to the right
         
         
         
   3. Y Offset – adjusts the position of the red box vertically(50% places it at the center):
      1. Lower number, box goes to the top
      2. Higher number, box goes to the bottom
         
         
         
4. Right-click to go back.
5. Click Apply to save the settings.