How to Set Your Swann Security Sensor to Pairing Mode
SWIFI-MOTION, SWIFI-WDOOR, SWIFI-LEAK, SWIFI-ISIREN
Setting the sensor or siren to pairing mode will:
- Allow you to update the Wi-Fi credentials within 3 minutes
- NOT unpair the camera from your Swann Security account.
NOTE: If the sensor or siren is paired to your account and the Wi-Fi details did not change, it will connect back to the same network once pairing mode times out after 3 minutes.
Re-insert the batteries to activate pairing mode.
Re-insert the batteries to activate pairing mode.
Re-insert the batteries to activate pairing mode.
Touch and hold the Touch button for 6 seconds to set to pairing mode.
DID YOU KNOW? The QR codes can be seen when you open the battery compartments or on its side. Visit this article to see exactly where it is placed, then follow the instructions indicated in the Swann Security app to complete the pairing setup.