Unable to playback videos remotely using SwannView Link app

Things to have:	Things to do:
Working local or remote access to the DVR or NVR. Installed the latest version of SwannView Link available.	Do a playback. Prevent not working playback.

 

Preventing playback to stop working

 

Changing bitrate via software

Make sure to set substream’s settings to its lowest possible setting. To do this, using  a  computer  that  has  remote  access,  go  to  Live  View on SwannView Link software. If there is no computer available, you can proceed to: 

1. At the right, under Device List, click the settings icon. 

2. Select Encode.
   

3. Change the Stream Type to Fluent and set the Maximum Bitrate (kbps) to its

   lowest. 

   
   
4. Click on OK to save the settings.
5. Make sure to do the same thing to other channels or just click Copy To and save the settings to all channels.
   
   

   Changing bitrate via Menu

   Make sure to set substream’s settings to its lowest possible setting. To do this, using a mouse and monitor connected to the DVR or NVR, right-click on your mouse and access the Menu.
   
   1. Go to RECORD > Encode.
   2. Change the Encoding Parameters to Substream.
   3. Set the Max. BitRate(Kbps) to its lowest setting.
   4. Click on Apply to save the settings.
   5. Make sure to do the same thing to other channels or just click Copy To and save the settings to all channels.
   
   

   Always play in Fluent
   The app always play substream when doing playback using SwannView Link app; therefore, make sure to follow the suggested steps above.