How to Set Up HomeSafe View for PC and Mac
This guide helps you access your DVR/NVR using HomeSafe View on Windows or Mac.
Before you begin:
- Ensure your DVR/NVR is already installed and on your network.
- Confirm your DVR’s username and password are set.
- Download and install HomeSafe View:
Download the User Manual here:
Pick Your Situation
Choose the your starting point to get to the resolution:
1. How to Add the Recorder
Enter the following details:
- Device Factory: Private
- Device Name: Assign a name for easy identification.
- IP/ID: Enter the 20-character alphanumeric code found on your recorder
- Media Port: Default is 9000
- User Name: Default is admin
- Password: Enter your recorder's admin password
Click Add
NOTE: When you open HomeSafe View again, it will ask for a password. Default is blank, then click Login.
If that didn’t work, make sure that it is getting internet connection since we are adding it using its UID.
2. How to Load the Cameras
If that didn’t work...
Incorrect UID/Port?
Double-check your recorder’s UID or Media port by going to Menu → Network → Network.
Access denied?
Confirm proper login credentials and that remote access is enabled on your DVR’s settings.
Summary & Next Steps
- You’ve successfully added your DVR/NVR.
- Cameras are now imported and visible in Main View.
-
Still stuck?
- Revisit credential/UID accuracy, network settings, and Ethernet connection.
- If issues persist, contact Swann Support.